Specific cable / buyer evidence

Full reel or partial reel? Show the evidence

A reel label may show what the manufacturer shipped, not what a seller still holds after a cut or project overrun. The useful difference between “full” and “partial” is an evidence trail: original tag, current length method, open-end status and reel condition.

Submit cable details
Distinct buyer question

Document original factory put-up versus current remaining footage for full and partial reels.

Checkable specification fields

These are examples from the named references, not assertions about a reel you have not shown us. Match the actual jacket, tag and part number before using a product claim.

FieldDocumented example / boundarySource
Factory lengthsSouthwire says standard reels may have manufacturing tolerances and nonstandard lengths/reels may also exist.[1]
Original tag fieldsSouthwire lists product description, footage, gross/tare/net weights, maker, stock number and manufacture date.[1]
Different put-upsBelden 9262 lists both 100-ft and 1,000-ft reel variants for one product family.[2]
Certification cautionUL places the complete Listing Mark on a reel tag or smallest container for a claimed Listed cable.[3]

Make two length columns

Write down the original factory put-up from the label and the current remaining length separately. The latter should state its basis—sequential marks, measurement, scale-supported estimate or seller estimate—and date. If the number is unknown, leaving it unknown is better than repeating an original 1,000-ft label.

  • Photograph the tag and any readable start/end sequence numbers.
  • State whether the reel is sealed, opened, cut back or made of remnants.
  • Disclose visibly damaged cable, open ends, bent flanges and unknown storage.

Create one record per meaningful variant

A mixed pile of reels with different type strings, sizes, lengths or condition should not receive a single blanket “full reel” description. A one-line-per-reel list lets a buyer compare what is actually on hand without implying availability, acceptance or a fixed freight arrangement.

  • Keep manufacturer/part, conductor count, AWG/kcmil and length basis on each line.
  • Use the existing quote checklist and photos to request a product-focused review.

Questions about this reel

Does the original 1,000-foot tag prove this reel is still full?

No. The tag reports an original put-up. Record the current continuous length separately, along with the measurement or sequence-mark method and when it was checked.

Can printed sequence numbers verify a partial reel length?

Readable start and end markings can support a length estimate when the cable is continuous and the sequence is understood. If an end, section or mark is missing, qualify the figure rather than asserting a precise current length.

Is a partial reel automatically scrap?

No. Identity, usable continuous length, condition and product fit matter to an individual review. Neither this guide nor an old reel tag promises resale value or acceptance.

Source notes and scope

The linked references support the specific examples above. Product designs and standards can change; seller-supplied markings, measured length and current condition require separate verification. Nothing here states that this buyer stocks, tests, guarantees or accepts a particular cable, or offers installation advice.

  1. Southwire Reel Packaging Information
  2. Belden 9262 Technical Data Sheet
  3. UL Wire and Cable Application Guide
CALL NOW